Dalian Youyan Plastic Machinery Co., Ltd.
Couplet: Feng Manager
Address: Chinese Lushunkou District of Dalian City, the three streams town (take Tuchengzi Dalian to Lushun Road westbound vehicle airport about 200 meters in front of about 100 meters)
Actually plastic film blowing machine maintenance and maintenance is very important
A lot of people don't pay attention to the maintenance of plastic blown film machine, plastic blow molding machine in maintenance and maintenance is very important, many of the regular plastic plastic blow molding machine manufacturers will be to conduct regular maintenance work. But the maintenance work as doctors cure, has always been sick to do the corresponding treatment measures. Here is some about blown film machine is the matters we should pay attention to in the process of production.
1. Clean the extrusion machine and die can use copper knife, rod or compressed air to clean up, but don't damage the screw and screw is bright and clean surface.
2. The feeding port also can't just gloves to prevent spinning machine. When the feed ban all metal impurities and operating small tools such as damage to the hard object fall into the barrel of the machine.
3. The machine needs to before starting the reduction gear, the lubrication device check to avoid dry operation damage the machine and noises.
4. The boot when the exercise should be raided each can power supply connection is disconnected, the leakage; To ensure the safety of the parts first before starting the normal, lest affect production.
5. Within the scope of film forming conditions, and improve the forming temperature, cooling air temperature and blowing ratio; Increasing the film turbidity and glossiness; Vice to improve.
6. Die discharge uniform, can wear gloves slowly lift pipe, pipe end will be closed at the same time, the micro into gas regulator, from central hole of the plug in a small amount of compressed air, and then carefully stiff foam frame, plates, and wear into the traction roller, guide roller and coiling (such as want embossing after embossing roll)
7. Of the pipe blowing compressed air pressure to appropriate, cannot make the pipe burst, and to guarantee the stability of membrane tube symmetry, relative to guarantee the quality of production.
8. For each factory is the production safety of the first place, blown film machine operation also need to pay attention to safety problem. Blown film machine of the array are not allowed to stand in front of.